Flat Bar To Reattach Siding

You ll want to work your way up and down the piece and keep pressure on the bottom of the piece above.

Flat bar to reattach siding.

After that slide your flat bar behind the vinyl siding. I might as well once it s cut you ll simply begin prying away the broken piece. Next use a table saw or circular saw to cut a new piece of vinyl siding to the same size as the damaged one. Now you can press down on the center piece of siding to remove its bottom lip from the bottom piece of siding and its off.

The tool is available at most hardware stores and usually costs less than 10. If it is sagging or has come loose from the outside of your house you canmot just drive a few nails through the siding to reattach it. You can do this with a small pry bar or by hand. Use the flat bar to pry up the siding and remove the nails.

Find metal siding trim at lowe s today. Drive flat bar into nails to bend them then tap siding to wall causing the nail heads to pop. Vinyl siding is hung loosely to allow it to expand and contract in the sun. Then you can insert a flat pry bar with masking tape on it and slide the bottom lip of the top piece away from the middle piece.

To remove the old siding simply score or cut away any old caulk or paint that might be in the joints. Remove the damaged panel s nails with a pry bar. Use a pry bar to remove fastening nails little by little as you work towards the opposite end of the panel. Only bend panels enough to gain access to the nails fastening the damaged panel to the side of your house.

Use flat bar to carefully pry up the siding course above. Now the top piece is free and you can remove the nails holding the center piece in place. Continue to slide the zip tool along the edge until the entire piece is freed. When the siding is unzipped bend it up out of the way using your elbow.