Flashing Against Existing Panel Siding

Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.

Flashing against existing panel siding.

Since newer installation guidelines do not recommend caulking this joint but instead recommend leaving a small gap and flashing behind the ends of the siding i think it is more prudent to add flashings when it is possible to do so. Using a metal j flashing between these types of transitions provides a barrier between siding and transitions that protects against water intrusion. Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia meets it. It is always recommended to install step flashing behind stucco dryvit wood panel lap siding vinyl siding cedar shingle siding etc.

On a wall to be covered with wood cement board vinyl or metal. Install the first length of z flashing. This aritcle describes the cause repair and prevention of leaks rot damage at a wood framed wall that was not properly flashed and sealed at the wall bottom. Flashing materials choices installation details specifications.

Flashing is a strip of metal usually aluminum about 8 inches long and bent at 90 degrees with each side at least 5 inches wide. Wall or siding connection to foundation top porch floors slabs. Above the roof sheathing. Or pull the nails out of the closest layer of siding and slip the flashing up under it and hopefully under the moisture barrier.

Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud. I cut the tape so that it laps onto the housewrap above and 3 in. In certain instances flashing may need to be installed on the exterior of siding. Install the flashing before you finish the top of the brick wall as the flashing must go behind the siding as well as behind and under the top row of bricks that angle outward to cover the top.

Cover with cap flashing. I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall. Imo and that is all it is. Lift the bottom shingle and slip in the kickout flashing.

The only way is to cut a groove in the siding and flash the roof wall intersection. Building wall or siding flashing details at horizontal surfaces. Slip in the flashing. If the kick out and step flashing can t tuck behind the siding screw on cap flashing to cover it then caulk along the top.

But the j cap also creates a consistent line.