Embed the corner step flashing in the caulk and nail it to the roof with two roofing nails.
Flashing a masonary chimney on a metal roof.
Metal roof stove pipe flashing flashing is a method of weatherproofing the base of a chimney.
Snip and bend a piece of prebent 8 in.
As a rule chimneys are either masonry or metal.
Flashing is often made of metal which is the norm on a metal roof.
Some chimneys are clad in wood stucco or aluminum siding.
Trim panels to fit around the chimney.
It is used to seal the gap between walls and intersecting roofs.
A do it yourself video detailing step by step how to flash a chimney with our metal roofing chimney kit.
It s typically made of thin pieces of impenetrable material which inhibits water leaking around the chimney preserving the building from moisture and mold issues.
Square step flashing to fit 1 1 2 in.
Hammer 2 roofing nails into the flashing and roof.
Metal roof flashing is a galvanized sheet metal that is bent at a 90 degree angle about 8 to 12 inches on each side of the angle.
Place a small drop of caulk where the roof and chimney meet at the chimney corner.
Round metal chimneys will be flashed much like pipes.
Bend legs up the chimney sides about 1 inch.
Panels above the chimney should be removed.
There are four main types of flashing that work with a masonry chimney.
Fold closure 90 degrees and.
The truth of the matter is that all these styles are useful if they are correctly installed.
Apply butyl tape to the underside of the closure.
Cut two opposing 45 degree notches into z closure to allow a 90 degree bend.
Step flashing is the flashing that is incorporated into the shingle.
Place the step flashing over the caulk and onto the chimney.
It can be made of a variety of materials depending on the type of roof and its pitch.
Typically chimney flashings are more complex than other types of roof flashings and are a common source of roof leaks.
Secure a shingle over the corner flashing using a hammer and roofing nail.
