Also called drip edge flashing or d metal they serve a vital function by directing water away from the fascia and into the gutter.
Fixing roof drip edge.
Once all the underlayment is applied go back and place.
Installing drip edge on your roof.
When lapping the eave metal overlap them so the seam faces away from the direction of prevailing view.
If the gutter is lower than the bottom edge of the drip edge install flashing behind.
Make sure the outer edge extends over the gutter.
Tip 2 is.
This is important to protect damage to your fascia soffits rafters.
If you run into issues with the overlap and need to resolve the gap review the following tips.
Align one end of the lower eave strip even with the edge of the roof decking.
Place a bead of roofing cement along the top edge of the drip edging and press down on the loose shingles.
Three tips for overlapping drip edge flashing.
Home centers sell rolls of 6 in.
Any damaged plywood should be replaced.
Step by step how to repair a roof edge finding the damage.
With without rain gutters.
Save yourself some.
If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the.
Drip edges are metal sheets usually shaped like an l installed at the edge of the roof.
Cut out the damaged section with a circular saw.
To locate rotted areas of the roof s edge gently lift up shingles with a pry bar or taping knife.
Tools supplies tin sn.
Install roof drip edge along the eaves add underlayment then place drip.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
Lift up roof shingles and nail the eave strip in place with galvanized.
To prevent causing damage to the roof shingles it is better to do this when the temperatures are warm enough to make the shingles pliable.
Use tin snips to cut the gutter apron flashing roll in two 3 in.
Then slip the roof drip edge under the shingles and the tar paper on the eaves.
Replacing drip edge eave strips.
Install the eave strips on the lower roof edges first with the eave strips under the shingles and felt underlayment.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
Overlap pieces at least a couple of inches shingle style with pieces higher up on the roof overlapping pieces lower.
If it doesn t pull the drip edge out slightly from under the shingles.
Secure the drip edge with roofing cement.
