Sensor is now reset.
Fibaro temperature sensor not working.
Do not place the sensor where it can be touched by people and animals or other objects that may heat or cool it and distort results.
It is not recommended to install the motion sensor in places prone to drafts and rooms with rapid fluctuations in air temperature.
I have tried to change reporting interval to 5 min and report hysteris to 1 degree but nothing happens.
The device driver for this device does not seem to support it in this mode since i can t change anything and logs show that it is just waiting for the device to wake up and report to send commands to it it won t wake up since it s always awake and waiting.
Only the value of the external sensor is reported.
I combined the excellence code from cyrilpeponnet the smartthings code for the sensors and come out with this version.
So far i only tested on the following parameters but it should work with the rest.
In this case you should.
The sensor s body and a magnet separate a radio signal is sent.
It should be kept in mind that the room temperature is not evenly distributed.
Back to course why cannot my fibaro motion sensor be included to my z wave controller.
It s not unnatural for somebody to think it s not working immediately and therefor check the battery inadvertently resetting the sensor.
Each time its two parts i e.
The accuracy of the temperature sensor is 0 5 c.
Sensor can be mounted using the included screw or the sticker.
In software version 4 4 and below the temperature of the internal sensor head of the fg bh t 001 thermostat is not reported to the control unit.
This version only tested on v3 2 of fibaro motion sensor it may not work on other version.
Fibaro motion sensor is included to another z wave controller fibaro motion sensor needs to be removed using z wave controller or reset by.
Do not cover the temperature sensor with anything.
If all the steps above fail you can ask fibaro support for help.
Radiators fireplaces cookers etc or at any source of light direct sunlight lamps.
Fibaro motion sensor cannot be pointed at any source of heat e g.
The fibaro door window sensor is a wireless battery powered z wave compatible reed sensor.
Fibaro smoke sensor not reporting temp.
A opening the device casing b holding down the b button until you see the yellow.
Would this mode be possibly supported mike maxwell so that.
In addition the fibaro door window sensor supports one ds18b20 temperature sensor and has one potential free input.
Step 6 is the tricky bit as it could take a couple of minutes for the sensor to stabilize and start reporting back on the z wave network.
This thread suggests that i should run a simulator to get the configuration downloaded correctly to the device.
